Monday, 18 June 2012

How To Make A Leather Necklace


Easy to make leather fringe necklace

Materials
1 piece leather approximately 18” x 3”
1- 16.5” Flat silver chain
2- Silver cone shaped cap ends- approximately ½” opening
2- 4" pieces silver wire

Tools
Ruler

Box cutter
Pliers

Carpenter’s glue


Instructions

1 Brush back of the leather to clean off excess - Cut 9 strips of leather ¼” wide x 18” long
2 Trim one end at a 45 degree angle (this makes the inside strips shorter than outside ones so the necklace hangs better)

1                                                          2

3 Punch holes both ends of leather strips (if you don’t have a punch cut small slits)
4 Run wire through the holes
                                 3                                                              4
5 Twist one end of wire to hold leather strips tightly together
6 Fold long end down and make a loop (loop should be ¼” to ½” longer than the cap end)
                          5                                                           6
7 Twist into place
8 Apply carpenter’s glue on end of leather
                    7                                                     8
9 Put silver cap end over end of leather- let dry 25 minutes
10 Once dry- open link on chain end and join to the wire loop
                           9                                                              10

Repeat on other end 













No comments:

Post a Comment